The gaugeART 52mm CAN Gauge & Panel Mount CAN Gauge support the following data channels. Click here for instructions to enable CAN telemetry.
Hondata KPRO 4:
- Air/Fuel Ratio
- Air Temp (ºF / ºC)
- Analog 0 – 7 (please click for special instructions on using Hondata KPRO 4 analogs)
- Battery Volts
- Coolant Temp (ºF / ºC)
- Engine Speed (RPM)
- Ethanol Content (%)
- Ethanol Temperature (ºF / ºC)
- Fuel Press (PSI)
- Gear
- Ignition Timing (º)
- Injector Timing (ms)
- Knock Count
- Lambda
- Manifold Pressure (PSI/KPA)
- Oil Press (PSI)
- Throttle Position
- Vehicle Speed (MPH / KPH)
Note that the Hondata KPRO4 does not include a terminating resistor onboard. A 120 ohm resistor must be soldered to the KPRO 4 circuit board between CAN L & CAN H terminals. See ECU manufacture’s instructions for more information.
CAN Output must be set to Hondata Protocol 250 kbps as shown below.
